Horizon 3000
Lamination Process and
The gel coat is manufactured by HK Research, It's a NPG-Isophthalic gel coat formulated to provide excellent blister resistance. It is applied 18-22 mils wet.
The skin layer is 2 oz. mat cloth with an AOC Iso/Ortho blend resin
The hull is built with E-QXM 4108, it is designed to optimize fiber orientation for marine hull laminates. This is an unbalanced quadriaxial fabric that has more fiber weight in the highest loaded angle to efficiently stiffen the unsupported panel. In a marine hull application, the 90-degree fiber is typically the most important orientation. More fiber weight is added to this angle to stiffen the shortest panel span. The zero degree fibers are needed for longitudinal stiffness and the +/-45 fibers are added for sheer properties. Mat is needed for inner laminate sheer.

The 60" wide cloth extends up and over the tunnel radius. With 3 layers of 4108 in each sponson and 3 layers of 4108 on top of the tunnel, it gives the hull a 6 layer overlap on the tunnel radius.
 The transom is cored with Coosa, 1.5" thick. It is encapsulated with a layer of 1.5oz mat and 3 layers of 4108. Each layer of 4108 wraps around the corner, onto the side of the boat.
The bulkheads are constructed out of 1.5" medium density Airex foam core. The foam bulkheads are bedded in bonding putty. The putty is shaped at a 45 degree angle to form a fillet at the edges.
The Airex foam core bulkheads are encapsulated with 4108 and tabbed to the hull.
The sub-floor foam core, in the fuel tank compartments, is glassed in with 1708 and the perimeter deck trough is glassed in on top of the bulkheads. A pair of 3" PVC tubes are glassed in for rigging tubes.
The bow bulkheads are constructed out of 1.5" medium density Airex foam core and laminated with a layer of 1708.
Limber holes are added to the bottom of each bulkhead and sleeved with 1" PVC to ensure that no water can be trapped in the hull.
A 1.5" thick foam stringer is glassed in, under the fuel tank compartment, for structural support of the fuel tank sub-floor.
The first layer of the cockpit sole is 3/4" medium density foam core. Prior to installation, each panel is glassed on the underside with a layer of 1708. The panels are bonded to the tunnel, bulkheads and perimeter trough with bonding putty and fasteners.
The next step is to laminate another layer of 3/4" foam core to the first layer, forming a 1.5" thick foam core deck. The second layer is bonded to the first with 3oz mat cloth and resin. Each panel of the second layer is installed in a different direction than the first, so no two joints overlap.
The cockpit sole is finished with 2 layers of 1.5 oz. mat cloth and a layer of 1708. 1.5" thick foam core gunnel supports are glassed to the side walls.